OpenVox D110P (1 port E1/T1)

The D110P supports E1, T1 and J1 environments. It is selectable on a per-card or per-port basis. This feature enables signaling translation between E1 and T1 equipments and allows inexpensive T1 channel banks to connect with E1 circuits. D110P supports industry standard telephony and data protocols, including Primary Rate ISDN (both N. American and Standard Euro) protocol families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side interfaces are supported. D110P works with Asterisk®, Elastix®, FreeSWITCH™, PBX in a Flash, trixbox®, Yate™ and IPPBX/IVR projects as well as other Open Source and proprietary PBX, Switch, IVR, and VoIP gateway applications.

Technical Specifications

• SingleT1/E1/J1 port with PCI interface for high performance voice and data applications

• Half-length PRI card 

• RJ48 connector

• 32 bit 33MHz PCI and fully PCI 2.3 compliant 

• 32 bit bus master DMA data exchanges across PCI interface at 132 Mbytes/sec

• Autosense compatibility with 5 V and 3.3 V PCI busses

• Power: 1.2W Maximum at 3.3 V or 5 V.